Home › Forums › Hobby › Works in Progress › Martian Scientist Tripod – Assembly (Pictures)
This topic contains 7 replies, has 1 voice, and was last updated by Gregg Dieckhaus 3 years, 8 months ago.
Here is a picture of all the pieces before starting
First step I had to use some sandpaper on the tripod Head mounting tube to allow it to slip into the collar.
Next attach the “body” to the collar. The legs will attach to the body, so you need so make sure to place this properly to allow the legs to be in the proper tripod positions.
Attach the legs – one at a time… in my case i used sponge material to help prop them up while glue dried.
(not sure why these are not rotated properly)
When I went to put the bottom plate on, one of the legs stuck up too high, so I had to remove it and trim down the top that stuck out. Then reattached
Then add the bottom plate
Stand Tripod up, add the wings. The hole that held the wing pins wasnt deep enough so those needed to be trimmed down to provide a flush mount to the tripod head.
Attach tentacles, and heat ray. Again you may need to trip these “pegs” so they fit flush with the holes. Position tentacles as desired.
Finally attach “tube” exhaust or whatever to the underbelly.
You are done!!
You must be logged in to reply to this topic.
Comments are closed